FIBERGLASS REINFORCED POLYPROPYLENE TANK
Clean & Clear Plus filters feature a corrosion-resistant, injection-molded filter housing for superior strength and reliability. The cartridge assembly uses four easy-to-clean, non-woven polyester cartridges. Each filter comes with a set of bulkhead fittings for easy installation.
Features:
- NSF Listed
- Superior resistance
- Large filter surface for increased dirt retention capacity
- 1-1/2" 100% Drain Cleanout
- Continuous high flow internal air discharge*
- Injection molded tank
- Balanced hydraulic flow
- Tension Control™ Clamp
- 100% factory tested
- Black bulkhead fittings
- High Flow Manual Air Relief Valve
Note: Actual system flow rate will depend on plumbing size and other system components. Pentair does not recommend flow rates greater than 150 GPM.
*Integrated high continuous flow internal air relief device operates only when flow in the circulation system is unobstructed. Operating Limits - Maximum continuous operating pressure 50 PSI. Pool/Spa (bather) applications, maximum operating water temperature (internal filter) 104 degrees F (40 degrees C).
Warranty Coverage: Pentair Clean and Clear cartridge filters are covered by a one-year limited manufacturer's warranty. The manufacturer warrants this filter against defects in workmanship and materials. This warranty will be void if the equipment used to operate this filter is not compatible or due to improper installation or use. The warranty does not cover labor charges, the cost of lost water or chemicals, or any other damage that may occur.
Suggested replacement filter: Pleatco for Pentair - PCC105 sold separately
